I am running hyperion on a pi4 and otherwise followed DrZzs tutorial step for step. However my lights do not seem to reacting to the screen what so ever. The capture card is recognized in the remote control section.
This is what my log says,
2021-03-20T04:31:00.515Z [hyperiond FRAMEBUFFERGRABBER] (ERROR) Error opening /dev/fb0, No such file or directory :
2021-03-20T04:34:30.708Z [hyperiond FRAMEBUFFERGRABBER] (DEBUG) (Grabber.cpp:90:setWidthHeight()) Set new width: 3840, height: 45 for capture
2021-03-20T04:34:30.788Z [hyperiond WEBSOCKET] (DEBUG) (JsonAPI.cpp:1063:handleLoggingCommand()) log streaming deactivated for client ::ffff:192.168.50.48
2021-03-20T04:34:56.369Z [hyperiond FRAMEBUFFERGRABBER] (DEBUG) (Grabber.cpp:90:setWidthHeight()) Set new width: 3840, height: 2160 for capture
2021-03-20T04:35:35.617Z [hyperiond V4L2:AUTO] (DEBUG) (V4L2Grabber.cpp:87:uninit()) uninit grabber: /dev/video0
2021-03-20T04:35:35.630Z [hyperiond V4L2:AUTO] (INFO) Stopped
2021-03-20T04:35:35.632Z [hyperiond V4L2:AUTO] (INFO) configured v4l device: /dev/video0
2021-03-20T04:35:35.633Z [hyperiond V4L2:AUTO] (DEBUG) (V4L2Grabber.cpp:696:init_device()) Set resolution to width=1920 height=1080
2021-03-20T04:35:35.634Z [hyperiond V4L2:AUTO] (DEBUG) (V4L2Grabber.cpp:713:init_device()) Set framerate to 5 fps
2021-03-20T04:35:35.634Z [hyperiond V4L2:AUTO] (DEBUG) (V4L2Grabber.cpp:735:init_device()) Pixel format=YUYV
2021-03-20T04:35:35.662Z [hyperiond V4L2:AUTO] (INFO) Started
2021-03-20T04:35:35.662Z [hyperiond V4L2:AUTO] (INFO) Signal detection area set to: 0.250000,0.250000 x 0.750000,0.750000
2021-03-20T04:35:35.662Z [hyperiond V4L2:AUTO] (INFO) Signal threshold set to: {12, 12, 12}
2021-03-20T04:43:51.729Z [hyperiond WEBSOCKET] (DEBUG) (JsonAPI.cpp:1054:handleLoggingCommand()) log streaming activated for client ::ffff:192.168.50.48
Does this tell you anything that might help me or how do I figure out what is going wrong?