Been looking into creating a new first time build for the past few days and was just hoping to get some input and/or some recommendations.
Here's my current parts list with an emphasis on simplicity and ease of use.
Raspberry Pi Zero W.
https://core-electronics.com.a…Xqu7Fciwx9qUaAhY3EALw_wcB
Capture Card.
https://www.amazon.com.au/gp/a…?smid=AB45PRC5K0YOC&psc=1
HDMI Splitter.
https://www.amazon.com.au/gp/a…smid=A2AFUPHXKS2512&psc=1
LED Strip.
https://www.amazon.com.au/gp/a…?smid=A4XRJ8S0WXSO0&psc=1
Power Supply.
https://www.amazon.com.au/gp/a…smid=A1JUHGLDN0W9DX&psc=1
End Connector. (Common ground with LED+Pi)
https://www.jaycar.com.au/2-1m…-screw-terminals/p/PA3713
Probably going to harvest an old Micro USB to power the Pi.
The length of the strip should be ~2.8-3m which gives me approximately 168 LED's total. My main concern is being able to power everything with the current choice of supply.
Going off this chart I have a little bit of wiggle room and if not am I able to power the strip from both ends?
https://hyperion-project.org/i…/3314-leds-and-specs-jpg/
Just looking for some input. Cheers.