Hey guys,
I followed the Steve Does Stuff guide down to a science and for what ever reason my lights are not working. I know for a fact that the Arduino can control the light properly because i've tried two Arduino scripts, one from the video and one I found on this forum. When the Pi powers the Arduino It sends a GRB signal to the lights and in another sketch they turn blink white for a second. (strangely in the second sketch at times the entire strip turns on showing different colors.)
My configs are right (I think) and my Pi is receiving proper signal from my capture card
Hardware: Pi 0W, Arduino Nano, and WS2812B Lights.
Software. 2.0.0-alpha.10
Arduino Setup: https://pastebin.com/XZQj02s3
I've been trying to do this for a week and I am so close I can basically taste it. Also looking at the log section under warnings im not seeing anything but where would I find the logs to post here?