I've got everything all set up with an (APA102) LED count of 266 (85 wide, 45 high). However, the last 12 LEDs are not working as they should (the first 5 light up with a consistent white, followed by an aqua colored one). I thought maybe I had a bad chip/connection on the strip, so I traced back to the last OEM solder points on the strip (every 30leds), cut it, and soldered on a new section. The strip was unresponsive starting in the exact same spot as it was prior to the splice (11 LEDs past this splice).
I've got power tapped in from two opposing corners to ensure power consistency. The LEDs that light up, seem to work great (however they seem to light up with various intensities of a subtle aqua color after the initializing rainbow swirl finishes).
Is there a limit of 254 LEDS within HyperCon, or are there limitations with the Raspberry Pi3 I'm using?
I'm still waiting on my capture device, so I can't do any sort of live stream testing yet, but it would be great to get through these hiccups so I'm ready to roll when it gets here.