1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

SOLVED Vertical is not working

Discussion in 'Software Support' started by ace16vitamine, 26 January 2019.

  1. ace16vitamine

    ace16vitamine New Member

    Messages:
    2
    Hardware:
    RPi3, +Arduino
    Dear all,

    I have a 144 LED Lightberry Set Setup.

    If i configure with Lightberry it is working, but if I configure with Hypercon configuration Tool it is only possible to see the horizontal LEDs and not the vertical (left and right).

    But... If i send a Color with hypercon tool all LEDs are working. I have no Idea what is wrong.

    Attached two config Files. One with the working Setup from Lightberry and the other one created by Hypercon and it is not working.

    Regards
    Stefan
     

    Attached Files:

  2. ace16vitamine

    ace16vitamine New Member

    Messages:
    2
    Hardware:
    RPi3, +Arduino
    Solved! I
     
    • Like Like x 1
  3. TPmodding

    TPmodding Administrator Staff Member Administrator

    Messages:
    1,208
    Hardware:
    RPi1/Zero, RPi2, RPi3, +Arduino, +nodeMCU/ESP8266
    and what was the issue?
     
  4. yom

    yom New Member

    Messages:
    2
    Hardware:
    RPi2, RPi3
    Hello,

    I have exactly the same issue... what did you do to solve it please ?
     
  5. yom

    yom New Member

    Messages:
    2
    Hardware:
    RPi2, RPi3
    I think the issue is related to crop option in grabber section. If crop is set to 0, vertical does not work.