I've looked through the help hoping someone else has fixed this issue already but haven't seen it yet. When plugging in my Raspberry Pi and my Lights the signal seems to be going through, however only the first LED is turning on. My setup is as follows:
- Raspberry Pi 3
- Hyperiban
- Aclorol WS2812B LED Strip Light 30 Pixels/M
- 5v 10A power supply for the LEDs
- MicroUSB power supply for the Raspberry Pi (included with the Pi)
- HDMI to USB capture card
I assumed this was an issue with a common ground, and when I spliced a micro USB into the adapter for the lights and ran it off the same power it worked, however that splice is pretty week (the cables are pretty small) and keeps falling out of the connector or the wires are breaking. To alleviate that I connected the LED's ground to a ground on the Pi and that also did not work. Worst case scenario I can work on the splicing and try to make that the permanent solution, but if I can avoid that I will.
Thanks in advance