Hello, i've made my ambilight project working last year with RPi+arduino+w2812b+openelec+hyperion, everithing was fine till one day the leds stoped working ... i've lost all my config files, and had to rewrite from what i found on web)
P.S. i'm a total noob!!
Leds not working
- nkgeorge
- Erledigt
-
-
// LED CONFIGURATION
"leds" :
This should have your LED count/origination/position. Have you used HyperCon to aid with the configuration? -
i didn't put 208 leds configuration here... i can if you want
-
"Upload the content of your "hyperion.config.json" to pastebin.com"..
read https://hyperion-project.org/t…you-open-a-new-thread.22/. it well help others with helping. -
ok, thanks, here is my config :
[MEDIA=pastebin]TKFYnvFG[/MEDIA]now i got problems with colorpicker :
ssh out: /storage/hyperion/bin/hyperion-remote.sh -c ff594b
ssh in: hyperion-remote:
ssh in: version : V1.03.3 (brindosch-2fbbcff/2f01dfa-1495880388
ssh in: build time: Jun 3 2017 02:06:16
ssh out: Unable to connect to hostbut videoframegrabber works
also i have hypercon v1.03.3 (22.10.2017) .. if i stop then start hyperion ..hypercon freeze and i have to close it from task manager.
another thing .. if i load hypercon setting .dat ... it allways switches from ttyUSB0 to ttySO and baud rate from 500.000 to 100.000p.s. this is my arduino setup
[MEDIA=pastebin]KAmsz7RD[/MEDIA] -
I would use this sketch. https://github.com/hyperion-pr…firmware/arduino/adalight.
-
thanks for the help
i've modified the sketch, changed the baud rate to 115200, remade the hypercon config .. pluged all in and it worked for kodi , not for videograbber
changed the priority channels.. and even kodi didin't work anymore... reboot the whole thing kodi works again but after 10 min i get the flshing purple light (arduino) and everything stops working. I might have a power supply problem.. must check.
Thank you for the sketch .. i will do some troubleshooting and come back here to reportL.E.
everything it's working now, and i didn't do anything special ( cold reboot) ... i think the arduino board it's the problemThanks for all the help
L.E. fixed everything, bought a new arduino nano and all the problems disappeared
Jetzt mitmachen!
Sie haben noch kein Benutzerkonto auf unserer Seite? Registrieren Sie sich kostenlos und nehmen Sie an unserer Community teil!