Hi everybody i have a problem with my setup as you can see in the videos. When i start hyperion the rainbow works perfectly. Also when i set the led colors through the colorwheel the colors are rocksolid and i can change them accordingly. (Video #1) But after the system is up and running the leds are flickering and are not corresponding the colors of the displayed live stream (Video #2) What is wrong and what am i doing wrong. Preconditions: OSMC is installed through hypersion --> so far all good My setup/wiring. Power supply: https://www.aliexpress.com/item/AC-DC-Power-Supply-5V-5A-6A-8A-10A-Adapter-Charger-Transformer-25W-60W-40W-50W/32756921792.html?spm=a2g0s.9042311.0.0.fPl6cS LED ws2801: https://www.aliexpress.com/item/1m-5m-WS2801-32leds-m-SMD-5050-RGB-LED-strip-Arduino-development-ambilight-TV-IP30-IP65/32708924761.html?spm=a2g0s.9042311.0.0.dijuU2 - From the LED strip start the plus(+) and ground cable are connected directly with my 8A power supply. - The LED strip end i have connected plus and ground again with the power supply. - The 8A power supply also delivers power to the HDMI splitter - And i also power the PI through pin 2(5volt) and pin6 (GND) - From the LED strip start the two other cables (DAT and CLK) i have soldered to pin 19 and 23 --> see pictures https://www.youtube.com/watch?v=A6bl1Jl04go https://www.youtube.com/watch?v=SmRhocnOHz4