Hi everybody
i have a problem with my setup as you can see in the videos. When i start hyperion the rainbow works perfectly. Also when i set the led colors through the colorwheel the colors are rocksolid and i can change them accordingly. (Video #1)
But after the system is up and running the leds are flickering and are not corresponding the colors of the displayed live stream (Video #2)
What is wrong and what am i doing wrong.
Preconditions: OSMC is installed through hypersion --> so far all good
My setup/wiring.
Power supply: https://www.aliexpress.com/ite…=a2g0s.9042311.0.0.fPl6cS
LED ws2801: https://www.aliexpress.com/ite…=a2g0s.9042311.0.0.dijuU2
- From the LED strip start the plus(+) and ground cable are connected directly with my 8A power supply.
- The LED strip end i have connected plus and ground again with the power supply.
- The 8A power supply also delivers power to the HDMI splitter
- And i also power the PI through pin 2(5volt) and pin6 (GND)
- From the LED strip start the two other cables (DAT and CLK) i have soldered to pin 19 and 23
--> see pictures