- Official Post
Dox I need to look into this myself again. I just updated my S1 to the latest firmware and it is not working any longer, too.
Before the update it was working... ![]()
Dox I need to look into this myself again. I just updated my S1 to the latest firmware and it is not working any longer, too.
Before the update it was working... ![]()
Dox What firmware do you have? You can check it in the Yeelight App or in HomeAssisten (iOS).
In case you have the Yeelight app, does the Music-Mode for for you?
If I start Music-Mode with FW 2.1.7_0037 in the iOS app, it fails even with the official app at my end.
Music-mode is the prerequisite to have Yeelight with Hyperion working.
Edit: Those Yeelight devices give me headaches...
I have now "rebooted" the S1 and the device works again.
To track down your issue:
a) Restart the device (disconnect power and connect again)
b) Please provide your FW and if music-mode works via the app
c) if music mode is working, plus hyperion into debug mode
d) run the wizard until your device shows up, do identify
if the device does not occur, press cancel and start the wizard again.
The device is not always reliable, therefore you might need to do multiple retires
e) Save the device
f) run a simple color effect or standard effect from the remote control
g) provide the log file, use the copy to clipboard button
Then we have a joined look at potential errors reported.
Lord-Grey, thanks for the support.
I did every step as instructed.
- My firmware is also 2.1.7_0037
- Music mode works with the app
- The log is attached
Hi!
Same problem I think, I am using Yeelight Smart Bulb W1 (RGB). Music mode works via my phone. Identify works after I manually added it by using a fixed IP address (192.168.0.131.
Log.txt
Would you mind sharing a log and on what platform you are running Hyperion?
There's a log in my previous post.
I am running Hyperion as a Home Assistant addon. I have a ESP8266 LED strip running from there as well as a test setup. It's currently doing Ambilight stuff for my monitor. That works fine.
As I've stated:
* Adding them manually works.
* Identification works.
* Running any effect from Hyperion does not work.
Don’t have an account yet? Register yourself now and be a part of our community!