Just installed Hyperion and it is up and running. Only issue is, I can't configure Hyperion because apparently, there is no IP address on the Raspberry Pi. It simply says to browse to http://:8090 with no IP in front of it. The Raspberry Pi should be connected to my network since I configured that in the Imager when downloading the software.
Any clues as to what the issue could be?
Edit: I have tried re-installing the software, but with no luck
No IP-Adress on Raspberry Pi 4 when booting with Hyperion?
- Str1kez
- Erledigt
-
I think, but it's only a quess..
Your router/switch doesn't provide the Raspi with dhcp IP adres, so the device doesn't receive IP adres. Hence, you cannot go to browser API
Normally Raspi boots under dhcp, static IP adres config isn't necessary (normally I have to say)
Check your connection/utp cable and see if LAN Raspi port gets green/orange lights blinking
Make sure router/switch puts out dhcp, or turn on dhcp server option 🤔
-
What do you get when you issue the command hostname -I
or ip a
?
-
Jetzt mitmachen!
Sie haben noch kein Benutzerkonto auf unserer Seite? Registrieren Sie sich kostenlos und nehmen Sie an unserer Community teil!