I have a Raspberry Pi 2 with 186 lpd8806 LEDs attached.
All was running well and then the SD card died after years of use, to be expected sometimes.
I rebuilt the system with a new SD card running Hyperion on top of Libreelec.
The last 2 LEDs stay full on (white) at all times even if I "tell" them all off or all red or green etc. and even when there is no signal.
Any ideas? The setup was fine in the past running on Openelec and running on Libreelec when I first switched.
Any info I should provide? Is there a way to individually address specific LEDs?
json attached is that helps.
Cheers