I'm currently trying to get hyperbian 17 to work.
I'm running a raspberry pi 0 w 2 with a 5v 10amp PSU and a set of BTS lighting 2812b LEDs.
I have the pi and the LEDs connected via a barrel jack and once plugged in the pi boots and I can access the GUI. After a few minutes the first led will turn on too a white/green/ or yellow color. There was one instance where 1/4 of the LEDs powered on but I then realized that my micro USB was smoking and I had wires touching (bad wiring in my part, but the LEDs briefly worked.)
I have the data cable connected to gpio 18.
I am getting and error.
ws281x' signals error: 'Failed to open. Error message: Hardware revision is not supported'
2021-11-10T02:05:24.067Z [FLATBUFCONN]