SP616E + WS2812B = AmbiLED problem

weisstbescheid · Nov 29th 2023

Hallo,

ich habe versucht den zu Hyperion hinzuzufügen, leider ohne Erfolg.

Das Device ist "AmbiLED" und nicht Adalight, es gibt bei google ein firmware upgrade, aber mit Loader und der Firmware bleibt das immer beim Upload bei mir hängen, es ist auch über 8 Jahre alt.

Gibt es andere alternativen wie ich "AmbiLED" als Steuergerät hinzufügen kann in der config?

pclin · Nov 29th 2023

Quote from AmbiLED HD setup for Hyperion on RaspBMC/OSMC

Unfortunately, configuration software is not including an option for AmbiLED HD hardware, but no worry, Hyperion is supporting it. Choose “Adalight” as LED Type Important: Choose Whilelvl as “0.50” or less. Do not choose more than 0.5 value. Output is “/dev/ttyAMA0″ for most of RaspberyyPi.

AmbiLED HD setup for Hyperion on RaspBMC/OSMC | AmbiLED HD

regards pclin

weisstbescheid · Nov 29th 2023

dont work, cant flash the firmware, if i flash than is uploading the data but the xloader is froze

//EDIT:

Enter this command to open text editor:
sudo nano /etc/hyperion.config.json
You will see inside of configuration file.
Find this line:
“type” : “adalight”
Replace the “adalight” part with “ambiled”

and this i cant find under windows

Lord-Grey · Nov 29th 2023

I would suggest you revisit the Baud rate.

The page pclin referred to shows a different one than you configured.

Edit: look in the comments of the Setup site

AmbiLED HD | High Definition Ambient Light by Inovatek Electronics

You need to go with 115200 Baud + Sperrzeit=30 (which you already have).

weisstbescheid · Dec 10th 2023

i tryed and still no connection

sad i will change to an ESP32

SP616E + WS2812B = AmbiLED problem

Participate now!

Tags