Hey everyone,
I've hit a wall with trying to get Hyperion to work on my Raspberry Pi setup, and I could really use some help. I've been at this for about a month now and have tried everything I can think of, but I'm still having issues.
Here's what I'm working with:
- MacBook Pro
- 7-inch Pi screen
- 2 Raspberry Pi 4s
- 1 Raspberry Pi Zero
- Keyboard and mouse for the Pi
I've tried running Hyperbian on all three Raspberry Pis multiple times, but I can't seem to get it to work. Every time I try to access the IP and port 8090, nothing happens. My router recognizes the connection, but both Firefox and Chrome fail to load the page. The only time I got it to work with the Pi 4 was when it was directly connected to the router, but that's not really practical for my setup.
I've also tried running Hyperion by installing it onto the Pi OS. I've installed Pi OS and then used the terminal to install Hyperion multiple times, but I'm encountering the same issues as above. Only once did it work, but then my LEDs didn't function properly because they were WS2812B Eco. Unfortunately, I erased everything and tried again, and now I can't remote connect at all.
I can't believe that all three of my Pis are defective, so I'm guessing the problem lies with me. I've followed every tutorial I could find, tried using different imaging software, and edited the wpa.suplicant.conf file in every way possible, but I still can't connect unless I'm hardwired to the router.
This whole situation is driving me crazy, and I'm about ready to give up. Please, if anyone has any suggestions or advice, I would greatly appreciate it. I feel like I've tried everything and I'm at my wit's end.
Thanks in advance for any help you can offer!