I can't control the LED strip

The LEDs light up white, but they do not respond to the Hyperion control, the operating system is Hyperbian, currently the Raspberry Pi 3b is connected through the Gio 18, a total of 100 LEDs, 5V at 14A power supply.

I attach the configuration and some images, thanks in advance.

This is the log:

ws2812 rgb

Sometimes a single LED also lights up and sometimes all at the same time.

Ok, I will solder the data cable to the gpio 18, do I have any way to know if the gpio 18 is outputting data?

Hello, I soldered the connectors and I can now control the LEDs, thank you very much, by the way, does anyone know how, if possible, to make the raspberry go into sleep mode, not turn it off, so that it does not heat up?

Finally, two questions, I have my own website to control hyperion in a simple way, does anyone know how I can request data on the status of etc.?

Could you leave me an example of querying the status of the leds?