Hi, I bought an
Help with power supply
- brownbear
- Unerledigt
-
-
Lord-Grey
Hat das Thema freigeschaltet. -
measure the polarity of the PSU, voltage has to be max 5.3 volts in case of 5 volt ledstrips.
Don't use barrel connector, they cause alot of resistance with high currents. Just use Wago's to connect the wires or solder the joints.
Did you power the ledstrip + and - from BOTH sides? It's recommended 👌 if ledstrip is one piece and has more pixel (leds) than 200
-
Cool. I’ll look for a multimeter and the Wago connector (wasn’t planning on the build to get this expensive 😂).
I forgot to mention that when I was testing the LEDs, I forgot that the 5m of LED is 90W, and the power supply can only handle at 75W. Although I am not entirely sure, I think that might have something to do with it since the power supply was at full load for ~5 minutes.
Also, the strips can be cut, and I will, but I’ll definitely buy another power supply for the other end just in case. 👍
-
300 x 49mA max. 15A
regards pclin
Jetzt mitmachen!
Sie haben noch kein Benutzerkonto auf unserer Seite? Registrieren Sie sich kostenlos und nehmen Sie an unserer Community teil!